LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1877 (Engine Mechanical - 2.4L (Lat)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Camshaft Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Camshaft Cover And Bolts
    GM1578306Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the camshaft cover and bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    2. Fig 2: Fuel Feed Line Retainers
    GM1647977Courtesy of GENERAL MOTORS CORP.
  2. Install the feed line retainers (1, 2) to the engine brackets.
    3. Fig 3: Identifying Camshaft Position Actuator Solenoid Valve Electrical Connectors
    GM1647538Courtesy of GENERAL MOTORS CORP.
  3. Install the ignition coils. Refer to Ignition Coil Replacement .
  4. Position the engine wiring harness and install the clips (4) to the cover.
  5. Connect the engine wiring harness electrical connectors (2, 3) to the intake and exhaust camshaft position actuator solenoid valves.
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About LEMON Manuals