LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1875 (Rear Drive Axle) >> Repair Instructions >> Vent Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Make note of the routing in order to aid in reassembly.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the right rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: Wheelhouse Liner & Pushpin Retainers
    GM1257378Courtesy of GENERAL MOTORS CORP.
  3. Release the pushpin retainers from the right rear wheelhouse liner and remove the liner.
    4. Fig 2: View Of Vent Hose Clips & Fuel Vent Pipe
    GM1340750Courtesy of GENERAL MOTORS CORP.
  4. Release the vent hose clips (2) from the fuel vent pipe (1).
    5. Fig 3: Removing/Installing Vent Hose On The Differential Assembly
    GM1340746Courtesy of GENERAL MOTORS CORP.
  5. Release the retaining clip (2) securing the vent hose along the top of the rear suspension crossmember.
  6. Remove the vent hose (1) from the differential assembly by carefully twisting the hose off of the barbed fitting.
scientia non olet · About LEMON Manuals