LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1875 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Right Rear Wheel & Tire Assembly
    GM693611Courtesy of GENERAL MOTORS CORP.
  1. Install the new output shaft seal using the J 44809  . See Special Tools .
  2. Install the right rear wheel drive shaft. Refer to Rear Wheel Drive Shaft Replacement .
  3. Inspect the rear drive module fluid level. Refer to Rear Axle Lubricant Level Inspection .
  4. Install the right rear wheel and tire assembly. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals