LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1875 (Rear Drive Axle) >> Repair Instructions >> Differential Housing Support Bushing Replacement >> Replacement

Differential Housing Support Bushing Replacement: Replacement

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing J 44866
    GM792837Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Remove the bushing only if damaged or worn out.
    IMPORTANT: Use the high pressure lube supplied with the tool.
  1. Install J 44866  . See Special Tools . Tighten the nuts in order to force out the bushing.
    2. Fig 2: Identifying J44866 For 4/6 Cylinder Vehicles
    GM925153Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The bushing has 2 slots molded into the rubber section. The slots are used to control vibration and must be installed in the following positions:
    • 4-Cylinder Vehicles - Align the slots in the 3 o'clock and 9 o'clock position (2).
    • 6-Cylinder Vehicles - Align the slots in the 6 o'clock and 12 o'clock position (1).
  2. Install J 44866  . See Special Tools . Tighten the nuts in order to force the bushing in.
scientia non olet · About LEMON Manuals