Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Propeller Shaft, Support Bearing & Bolts

Courtesy of GENERAL MOTORS CORP.

While supporting the front, center, and rear of the propeller shaft, install the propeller shaft to the vehicle.
Thoroughly clean the center bearing to vehicle mounting bolts and apply thread locker, Saturn P/N 21005994 (Canadian P/N 10953488), to the bolt threads.
Install, but do not tighten, the support bearing mounting bolts.

Fig 2: View Of Propeller Shaft

Courtesy of GENERAL MOTORS CORP.

Pull the forward section of the propeller shaft rearward and install the propeller shaft to the PTU flange.
Align the index marks on the propeller shaft constant velocity joint and the PTU flange.
Thoroughly clean the propeller shaft flange mounting bolts and apply threadlocker, Saturn P/N 21005994 (Canadian P/N 10953488), to the bolt threads.

NOTE: Refer to Fastener Notice .

Install the front propeller shaft mounting bolts.
Tighten: Tighten the bolts to 25 N.m (19 lb ft).

Fig 3: Removing/Installing Propeller Shaft Flange Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Align the index marks on the propeller shaft yoke flange and the rear drive module flange and install the propeller.
Thoroughly clean the yoke mounting bolts and apply threadlocker, Saturn P/N 21005994 (Canadian P/N 10953488), to the bolt threads.
Install the bolts to the propeller shaft yoke and rear drive module flange.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).
Tighten the support bearing mounting bolts.
Tighten: Tighten the bolts to 25 N.m (19 lb ft).

Fig 4: View Of Propeller Shaft

Courtesy of GENERAL MOTORS CORP.

Remove the support stands from the propeller shaft.
Install the guard loop to the vehicle underbody.
Install the bolts to the guard loop.
Tighten: Tighten the bolts to 25 N.m (19 lb ft).
Lower the vehicle.