Tool Required

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

J 44870 Yoke Installer. See Special Tools .

Fig 1: Installing Support Bearing Using J44870

Courtesy of GENERAL MOTORS CORP.

Using J 44870 , install the support bearing on the drive shaft until it seats firmly. See Special Tools .

Fig 2: Aligning Splines On The Shaft & On The Yoke

Courtesy of GENERAL MOTORS CORP.

Align the splines on the shaft and the splines on the yoke.
Using J 44870 , install the yoke (2) on the drive shaft (1) until the lock ring groove is visible. See Special Tools .

Fig 3: Removing/Installing Lock Ring From The Groove

Courtesy of GENERAL MOTORS CORP.

Install the lock ring (1) in the groove.

Fig 4: Removing/Installing Universal Joint Caps & Retaining Clips

Courtesy of GENERAL MOTORS CORP.

Install the universal joint caps and the retaining clips.