LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1869 (Automatic Transaxle - 4T45-E - DTC P0843 To DTC P2637) >> DTC P2534 (2.4L Hybrid) >> Conditions for Clearing the DTC

Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
DTC P2534 (2.4L Hybrid)

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Install a scan tool.
  2. Turn ON the ignition with the engine OFF.
  3. IMPORTANT: Before clearing the DTC, use the scan tool in order to record the Freeze Frame and Failure Records. Using the Clear Info function erases the Freeze Frame and Failure Records from the TCM.
  4. Record the DTC Freeze Frame and Failure Records.
  5. Clear the DTC.
Did DTC P2534 reset?
Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections
3
  1. Remove the TRANS fuse.
  2. Inspect the fuse for an open. Refer to Circuit Protection - Fuses .
Did you find the condition?
Go to Step 4  Go to Step 5 
4 Test the ignition 1 voltage circuit of the TCM for a short to ground between the underhood fuse block and the TCM. Refer to Testing for Short to Ground and Wiring Repairs .
Did you find and correct the condition?
Go to Step 7  -
5 Test the ignition 1 voltage circuit of the TCM for an open between the underhood fuse block and the TCM. Refer to Testing for Continuity and Wiring Repairs .
Did you find and correct the condition?
Go to Step 7  Go to Step 6 
6 Replace the TCM. Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?
Go to Step 7  -
7 Perform the following procedures in order to verify the repair:
  1. Select DTC.
  2. Select Clear Info.
  3. Start the vehicle.
  4. Select Specific DTC.
  5. Enter DTC P2534.

Has the test run and passed?
Go to Step 8  Go to Step 2 
8 With the scan tool, observe the stored information, capture info, and DTC info.
Does the scan tool display any DTCs that you have not diagnosed?
Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK