Circuit/System Verification
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- If there are any other DTCs set, refer to DTC INDEX .
- Compare the desired engine idle speed to the actual engine idle speed with a scan tool. Actual engine idle speed should be no greater than or less than 100 RPM of desired.
- With a scan tool in output controls, increase the engine speed in 25 RPM increments while comparing the desired engine speed to the actual engine speed. The actual engine speed should stay within 25 RPM of the desired engine speed.