LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1860 (Engine Controls And Fuel - 2.2L (L61) - DTC P0201 To DTC P0651) >> DTC P0507 >> Test Description

Test Description

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  This test determines whether the engine can achieve the commanded RPM.
DTC P0507

Step Action Yes No
Schematic Reference:  Engine Controls Schematics 
Connector End View Reference: Engine Controls Connector End Views or Engine Control Module Connector End Views
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Start the engine.
  2. Command the engine speed up to 1,500 RPM, down to 500 RPM, and up to 1,500 RPM with a scan tool.
  3. Exit the RPM control function.
Does the engine speed correspond within 100 RPM with each command?		 Go to Intermittent Conditions Go to Step 3 
3 Inspect for the following conditions:
  • Vacuum leaks
  • Excessive deposits in the throttle body
  • A faulty positive crankcase ventilation (PCV) valve

Did you find and correct the condition?		 Go to Step 4  -
4
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?		 Go to Step 2  Go to Step 5 
5
IMPORTANT: Be aware that repairing one individual condition may correct more than one DTC.
Observe the Capture Info with a scan tool.Are there any DTCs that have not been diagnosed?		 Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK
scientia non olet · About LEMON Manuals