Conditions for Clearing the MIL/DTC
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
- A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Clear the MIL and the DTC with a scan tool.
DTC P0315
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Controls Connector End Views or Engine Control Module Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
IMPORTANT:
The Crankshaft Position (CKP) System Variation Learn Procedure may have to be repeated up to 5 times before the procedure is learned for various reasons. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn
.Does the scan tool display Learned This Ignition? |
Go to Step 4 | Go to Step 3 |
| 3 | If the CKP system variation learn procedure cannot be performed successfully, inspect for the following conditions:
Did you find and correct the condition? |
Go to Step 4 | - |
| 4 |
|
Go to Step 2 | Go to Step 5 |
| 5 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
Go to Diagnostic Trouble Code (DTC) List - Vehicle | System OK |