Test Description

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

2: Performing this step helps verify that an external anomaly, such as Electromagnetic Interference (EMI), did not cause the code to set originally.

DTC P062F (2.4L BAS)

Step	Action	Value(s)	Yes	No
1	Did you perform the Diagnostic System Check - Vehicle?	-	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Install a scan tool. Turn ON the ignition with the engine OFF. IMPORTANT: Before clearing the DTC, use the scan tool in order to record the ECM Freeze Frame and the TCM Failure Records. Using the Clear Info function erases the Freeze Frame and Failure Records from the ECM and the TCM. Using the Clear Info function erases stored DTCs in both the ECM and TCM. Record the DTC Failure Records. Clear the DTC. Turn OFF the ignition for at least 30 seconds. Turn ON the ignition with the engine OFF. Did DTC P1621 reset?	-	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections
3	Replace the TCM. Refer to Control Module References for replacement, setup, and programming. Is the action complete?	-	Go to Step 4	-
4	Perform the following procedures in order to verify the repair: Select DTC. Select Clear Info. Turn ON the ignition with the engine OFF for more than 2 seconds. Select Specific DTC. Enter DTC PP062F. Has the test run and passed?	-	Go to Step 5	Go to Step 2
5	With the scan tool, observe the stored information, capture info and DTC info. Does the scan tool display any DTCs that you have not diagnosed?	-	Go to Diagnostic Trouble Code (DTC) List - Vehicle	System OK