Test Description
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
The number below refers to the step number on the diagnostic table.
- 3: Tests for a magnetic field near the ignition lock cylinder.
DTC B3033
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Immobilizer Schematics Connector End View Reference: Immobilizer Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle i |
| 2 |
IMPORTANT:
Do not start the vehicle.
|
Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections |
| 3 | Inspect the area around the ignition lock cylinder for any device which could create a magnetic field such as an audio speaker, magnet, etc. Is there a magnetic device near the ignition lock cylinder? |
Go to Step 4 | Go to Step 5 |
| 4 | Remove the device creating the magnetic force. Did you complete the repair? |
Go to Step 8 | - |
| 5 | Inspect for poor connections at the Passlock™ sensor. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 8 | Go to Step 6 |
| 6 | Replace the Passlock™ sensor. Refer to Ignition Lock Cylinder Case Replacement
. Did you complete the replacement? |
Go to Step 7 | - |
| 7 | Perform the Programming Immobilizer System Components procedure. Is the repair complete? |
Go to Step 8 | - |
| 8 |
IMPORTANT:
You may have to wait up to 10 minutes in order to reset the BCM and synchronize all of the Passlock™ components.
IMPORTANT:
Do not start the vehicle.
|
Go to Step 3 | System OK |