Conditions for Clearing the MIL/DTC
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- The BCM no longer detects an open in the security indicator control circuit.
- A scan tool is used to clear the DTC.
DTC B0689
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Theft Deterrent System Schematics Connector End View Reference: Vehicle Access Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
Go to Step 6 | Go to Step 4 |
| 4 | Test for an open or short to ground in the security indicator control circuit. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 9 | Go to Step 5 |
| 5 | Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 9 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 7 | Replace the IPC. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 9 | - |
| 8 | Replace the BCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 1 |