LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1847 (Seat Heating System And Seat Cooling System) >> Repair Instructions >> Front Seat Back Heater Element Replacement (Non-Fold Flat) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat. Refer to Front Seat Replacement - Bucket .
  2. Remove the outer trim panel from the seat cushion. Refer to Front Seat Cushion Outer Trim Panel Replacement (2-Way) or Front Seat Cushion Outer Trim Panel Replacement (4-Way) or Front Seat Cushion Outer Trim Panel Replacement (6-Way) .
  3. Remove the armrest from the seat. Refer to Front Seat Armrest Replacement .
  4. Disconnect the electrical connector from the seat heat module.
    5. Fig 1: Locating Seat Back Cover Hook Retainers
    GM866891Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the lower J-hook retainer from the seat back trim cover.
  6. Carefully lift the trim cover, disengaging the hook and loop retainers until the heater element is exposed.
    7. Fig 2: Removing/Installing Element From The Seat Back Pad
    GM987728Courtesy of GENERAL MOTORS CORP.
  7. Gently pull on the heater element in order to remove the element from the seat foam. Be careful not to damage the foam pad.
scientia non olet · About LEMON Manuals