LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1847 (Seat Heating System And Seat Cooling System) >> Repair Instructions >> Front Seat Back Heater Element Replacement (Non-Fold Flat) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Element From The Seat Back Pad
    GM987728Courtesy of GENERAL MOTORS CORP.
  1. Peel off the self-stick tape from the back side of the heater element.
  2. Position the heater element over the seat foam pad. Press firmly to engage the adhesive.
  3. Lower the seat back trim cover, pressing on the hook and loop retainers in order to engage the retainers.
    4. Fig 2: Locating Seat Back Cover Hook Retainers
    GM866891Courtesy of GENERAL MOTORS CORP.
  4. Connect the lower J-hook retainer to the seat back trim.
  5. Connect the electrical connector to the heater element module.
  6. Install the armrest to the seat. Refer to Front Seat Armrest Replacement .
  7. Install the outer trim panel to the seat cushion. Refer to Front Seat Cushion Outer Trim Panel Replacement (2-Way) or Front Seat Cushion Outer Trim Panel Replacement (4-Way) or Front Seat Cushion Outer Trim Panel Replacement (6-Way) .
  8. Install the front seat. Refer to Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals