LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1847 (Seat Heating System And Seat Cooling System) >> Repair Instructions >> Front Seat Back Heater Element Replacement (Fold Flat) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat. Refer to Front Seat Replacement - Bucket .
    2. Fig 1: View Of Front Seat Back Recliner Trim Panel
    GM981031Courtesy of GENERAL MOTORS CORP.
  2. Remove the screws from the outboard recliner trim panel. Remove the trim panel.
    3. Fig 2: Removing/Installing Inboard Recliner Trim Panel
    GM981057Courtesy of GENERAL MOTORS CORP.
  3. Remove the screws from the inboard recliner trim panel. Remove the trim panel.
  4. Remove the head restraint. Refer to Front Seat Head Restraint Replacement .
  5. Disconnect the electrical connector from the seat heater element.
    6. Fig 3: View Of Seat Back Frame Bolts
    GM873654Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts from the seat back frame. Remove the seat back assembly.
    7. Fig 4: Removing/Installing Screws At Seat Back Panel
    GM981048Courtesy of GENERAL MOTORS CORP.
  7. Remove the screws from the back panel. Remove the back panel.
  8. Remove the armrest. Refer to Front Seat Armrest Replacement .
    9. Fig 5: View Of Lower J-Hook Retainer
    GM981476Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the lower J-hook retainer from the seat back trim cover.
  10. Lift the trim cover, carefully disengaging the hook and loop retainers until the heater element is exposed.
    11. Fig 6: Removing/Installing Element From The Seat Back Pad
    GM987728Courtesy of GENERAL MOTORS CORP.
  11. Gently pull to remove the element from the seat back pad. Be careful not to damage the pad.
scientia non olet · About LEMON Manuals