Circuit/System Description

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The auxiliary power module (APM) temperature sensor is used for overheat protection. The thermistor is located on the control board, near the phase APM power MOSFET. The starter/generator control module (SGCM) monitors the APM temperature sensor for the following:

To detect if the APM temperature sensor is shorted low.
To detect if the APM temperature sensor is shorted high.

If one of the above conditions is detected, the SGCM will set the appropriate DTC.