LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Engine Controls And Fuel - 2.4L (Lat) - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: MAF/IAT Sensor
    GM1820845Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor (2).
    2. NOTE: Refer to Fastener Notice .
  2. Install the MAF/IAT sensor screws (1).

    Tighten:  Tighten the screws to 0.6 N.m (5 lb in).

    3. Fig 2: Locating Mass Air Flow (MAF)/intake Air Temperature (IAT) Sensor Connector
    GM1814555Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (1) to the MAF/IAT sensor.
scientia non olet · About LEMON Manuals