LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Engine Controls And Fuel - 2.4L (Lat) - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying MAP Sensor
    GM1581050Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the NEW MAP sensor seal with clean engine oil.
  2. Install the MAP sensor into the intake manifold.
  3. Connect the engine harness electrical connector to the MAP sensor.
  4. Install the throttle body. Refer to Throttle Body Assembly Replacement .
scientia non olet · About LEMON Manuals