Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The oxygen sensor uses a permanently attached pigtail and connector. Do not remove the pigtail from the oxygen sensor. Damage to or removal of the pigtail connector could affect proper operation of the oxygen sensor.

NOTE: The use of excessive force may damage the threads in the exhaust manifold/pipe.

IMPORTANT:

The in-line connector and louvered end must be kept clear of grease, dirt or other contaminants. Avoid using cleaning solvents of any type. DO NOT drop or roughly handle the heated oxygen sensor (HO2S).
The HO2S may be difficult to remove when the engine temperature is less than 48°C (120°F).

Fig 1: Identifying Engine Harness Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the connector position assurance (CPA) retainer.
Disconnect the HO2S electrical connector (4) from the engine wiring harness electrical connector (3).

Fig 2: HO2S

Courtesy of GENERAL MOTORS CORP.

Remove the HO2S using the J 39194 . See Special Tools .