LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Engine Controls And Fuel - 2.4L (Lat) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Evaporative Emission Vent Solenoid
    GM927741Courtesy of GENERAL MOTORS CORP.
    CAUTION: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
    IMPORTANT: The evaporative emission (EVAP) vent solenoid is located on the top of the EVAP canister.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. IMPORTANT: Take care when removing the EVAP vent solenoid from the EVAP canister. Fuel vapor lines are fragile.
  2. Remove the EVAP canister-to-underbody bolts and slightly lower the EVAP canister enough to remove the EVAP vent solenoid.
  3. Disconnect the EVAP vent solenoid electrical connector.
    4. Fig 2: View Of EVAP Vent Solenoid
    GM932641Courtesy of GENERAL MOTORS CORP.
  4. Turn the EVAP vent solenoid counter clockwise and remove from the EVAP canister.
scientia non olet · About LEMON Manuals