LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Engine Controls And Fuel - 2.4L (Lat) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the EVAP vent solenoid electrical connector.
    2. Fig 1: View Of EVAP Canister-To-Body Underbody Fasteners
    GM1226414Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the EVAP canister-to-body underbody fasteners.

    Tighten:  Tighten the nuts to 8 N.m (71 lb in).

    3. Fig 2: View Of Evaporative Emission Canister
    GM1226407Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP canister purge and vent lines to the EVAP canister.
    4. Fig 3: View Of EVAP Canister Fresh Air Line
    GM933920Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister fresh air line to the fuel tank fresh air line.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals