LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Engine Controls And Fuel - 2.4L (Lat) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying EVAP Canister Purge Valve
    GM1578478Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister purge valve to the bracket.
  2. Position the EVAP canister purge valve with bracket to the cylinder head.
    NOTE: Refer to Fastener Notice .
  3. Install the EVAP canister purge valve bracket bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    4. Fig 2: Identifying EVAP Canister Purge Solenoid Valve Tube
    GM1571757Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister purge valve tube. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Connect the chassis EVAP vapor line to the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 3: Locating EVAP Canister Purge Valve Electrical Connector
    GM1578477Courtesy of GENERAL MOTORS CORP.
  6. Connect the EVAP canister purge valve electrical connector.
  7. Install the generator battery control module cover.
scientia non olet · About LEMON Manuals