LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Engine Controls And Fuel - 2.4L (Lat) - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Starter And Engine Electrical Connectors
    GM1809558Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
    3. Fig 2: View Of Starter And Electrical Connectors
    GM1813964Courtesy of GENERAL MOTORS CORP.
  3. Remove the positive battery cable nut (4) from the starter solenoid.
  4. Remove the positive battery cable (1) from the starter solenoid.
    5. Fig 3: Identifying CKP Sensor
    GM1578475Courtesy of GENERAL MOTORS CORP.
  5. Remove the CKP sensor bolt.
  6. Remove the CKP sensor.
scientia non olet · About LEMON Manuals