LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Engine Controls And Fuel - 2.4L (Lat) - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CKP Sensor
    GM1578475Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the CKP sensor O-ring seal with clean engine oil.
  2. Install the CKP sensor.
    NOTE: Refer to Fastener Notice .
  3. Install the CKP sensor bolt.

    Tighten:  Tighten the sensor bolt to 10 N.m (89 lb in).

    4. Fig 2: View Of Starter And Electrical Connectors
    GM1813964Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the engine harness terminal (4) is still installed on the starter solenoid.
  4. Install the positive battery cable (1) to the starter solenoid.
  5. Install the positive battery cable nut (4) to the starter solenoid.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

    6. Fig 3: View Of Starter And Engine Electrical Connectors
    GM1809558Courtesy of GENERAL MOTORS CORP.
  6. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
  7. Install the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement .
scientia non olet · About LEMON Manuals