LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Engine Controls And Fuel - 2.4L (Lat) - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement - Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Inspect the CMP sensor for damage, replace as necessary.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
  2. Install the CMP sensor. (Intake CMP shown, exhaust CMP similar).
    NOTE: Refer to Fastener Notice .
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Locating Exhaust CMP Sensor Connector
    GM1815153Courtesy of GENERAL MOTORS CORP.
  4. Connect engine wiring harness electrical connector (1) to the exhaust CMP sensor.
scientia non olet · About LEMON Manuals