LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Engine Controls And Fuel - 2.4L (Lat) - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Wiring Harness Electrical Connectors
    GM1811485Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Disconnect the engine wiring harness electrical connectors (2, 3) from the appropriate camshaft position (CMP) actuator solenoid valve.
    3. Fig 2: Identifying CMP Actuator Solenoid Valve
    GM1578482Courtesy of GENERAL MOTORS CORP.
  3. Remove the exhaust (1) CMP actuator solenoid valve bolt and valve, if required.
  4. Remove the intake (2) CMP actuator solenoid valve bolt and valve, if required.
  5. Inspect the solenoid valve O-ring seals for damage, replace as necessary.
scientia non olet · About LEMON Manuals