LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Engine Controls And Fuel - 2.4L (Lat) - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CMP Actuator Solenoid Valve
    GM1578482Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Lubricate the solenoid valve O-ring seals with clean engine oil.
  2. Install the intake (2) CMP actuator solenoid valve and bolt, if required.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Install the exhaust (1) CMP actuator solenoid valve and bolt, if required.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Identifying Engine Wiring Harness Electrical Connectors
    GM1811485Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (2, 3) to the appropriate CMP actuator solenoid valve.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About LEMON Manuals