LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Engine Controls And Fuel - 2.4L (Lat) - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of APP Sensor Harness Connector
    GM927716Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the instrument panel wiring harness electrical connector from the accelerator pedal position (APP) sensor.
    2. Fig 2: View Of Accelerator Pedal Position Assembly
    GM898158Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Due to clearance issues, the upper bolt cannot be removed from the sensor. Loosen the bolt and leave the bolt in the sensor until the sensor is removed.
  2. Remove the APP sensor bolt.
  3. Remove the APP sensor.
scientia non olet · About LEMON Manuals