LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1843 (Engine Controls And Fuel - 3.5L (L66) - Introduction (2 Of 2)) >> Repair Instructions >> Secondary Fuel Tank Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank Module
    GM1226439Courtesy of GENERAL MOTORS CORP.
  1. If the fuel level sending unit is being replaced, install the fuel level sending unit into the new fuel pump. Refer to Fuel Level Sensor Replacement - Secondary .
    2. Fig 2: View Of Suction Port
    GM1346873Courtesy of GENERAL MOTORS CORP.
  2. Connect the suction port.
  3. Insert the new secondary fuel pump module with the level sender and new fuel pump-to-tank seal. Ensure the orientation tabs are aligned.
  4. Use the SA9156E  to install the fuel pump lock ring.
  5. Connect the EVAP line quick connect.
  6. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals