LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1843 (Engine Controls And Fuel - 3.5L (L66) - Introduction (2 Of 2)) >> Repair Instructions >> Rocker Arm Oil Pressure Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Flow Control Module
    GM1236195Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the NEW O-ring and switch.

    Tighten:  Tighten the switch to 22 N.m (16 lb ft).

  2. Install the splash shield. Refer to Engine Splash Shield Replacement .
  3. Install the wheel. Refer to Tire and Wheel Removal and Installation .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals