Removal Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Blow dirt out of the fitting using compressed air.
- Depress the retaining tab (2) while holding the connector housing (1).
- Continue to depress the retaining tab while pulling the connector apart.
- Wipe off the male end using a clean shop towel.
- Inspect both ends of the fitting for dirt and burrs.
- Clean or replace the components as required.
CAUTION:
Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.
NOTE:
If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.