LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1843 (Engine Controls And Fuel - 3.5L (L66) - Introduction (2 Of 2)) >> Repair Instructions >> Intake Air Temperature Sensor 2 Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Air Temperature (IAT) Sensor 2
    GM1233528Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the IAT sensor to the side of the intake manifold (5).

    Tighten:  Tighten the IAT sensor to 18 N.m (13 lb ft).

  2. Connect the IAT sensor harness connector. Push in the connector until a click is heard, then pull back to confirm a positive engagement.
scientia non olet · About LEMON Manuals