LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1843 (Engine Controls And Fuel - 3.5L (L66) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
    IMPORTANT: The EVAP vent solenoid is located on the top of the EVAP canister.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of EVAP Canister-To-Body Underbody Fasteners
    GM1226414Courtesy of GENERAL MOTORS CORP.
  2. Remove the EVAP canister bolts.
  3. Disconnect the electrical connector from the evaporative emission EVAP canister vent solenoid valve.
  4. Disconnect the EVAP canister lines.
  5. Remove the EVAP canister from the vehicle.
    6. Fig 2: Rotating EVAP Canister Vent Valve
    GM889735Courtesy of GENERAL MOTORS CORP.
  6. Rotate the EVAP canister vent valve counterclockwise to release from the locked position.
    7. Fig 3: View Of EVAP Canister Vent Valve
    GM889736Courtesy of GENERAL MOTORS CORP.
  7. Remove the vent valve from the EVAP canister.
scientia non olet · About LEMON Manuals