LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1843 (Engine Controls And Fuel - 3.5L (L66) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Evaporative Emission Canister
    GM1226407Courtesy of GENERAL MOTORS CORP.
    CAUTION: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
    IMPORTANT: The evaporative emission (EVAP) canister is located under the center of the vehicle. It has 3 EVAP line connections:
    • The EVAP fresh air hose
    • The EVAP purge connection
    • The EVAP vent connection
  1. Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the EVAP canister fresh air line from the fuel tank fresh air line.
  3. Disconnect the EVAP canister purge line and vent line from the EVAP canister.
    4. Fig 2: View Of EVAP Canister-To-Body Underbody Fasteners
    GM1226414Courtesy of GENERAL MOTORS CORP.
  4. Remove the EVAP canister-to-underbody fasteners.
  5. Disconnect the EVAP vent solenoid electrical connector.
  6. Remove the canister from the vehicle.
scientia non olet · About LEMON Manuals