LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1842 (Wheel Drive Shafts) >> Repair Instructions >> Intermediate Shaft Replacement (L66) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Wheel Drive Shaft Into Transaxle Through J 44394
    GM857191Courtesy of GENERAL MOTORS CORP.
  1. Install the J 44394  to the transaxle oil seal. See Special Tools .
  2. Install the intermediate drive shaft to the transaxle.
  3. Remove the J 44394  when the intermediate shaft splines pass the oil seal. See Special Tools .
  4. Ensure that the intermediate drive shaft is fully seated by grasping the intermediate drive shaft and attempting to pull free of the transaxle.
  5. Position the support bracket to the engine.
    6. NOTE: Refer to Fastener Notice .
  6. Install the support bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  7. Install the O-ring seal to the intermediate drive shaft.
  8. Install a new wheel drive shaft retaining ring to the intermediate drive shaft.
  9. Install the right wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement (Non Hybrid)  or Front Wheel Drive Shaft Replacement (Hybrid) .
  10. Install the right tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals