LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1841 (Power Steering System) >> Diagnostic Information and Procedures >> DTC C0545 >> Test Description

Test Description

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  This step tests the torque sensor in its active state.
DTC C0545

Step Action Values Yes No
Schematic Reference: Power Steering Schematics 
Connector End View Reference: Power Steering Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Install a scan tool.
  2. Start the engine.
  3. With the scan tool, observe the Torque Sensor Main data parameter in the EPS Data List 2.
  4. Turn the steering wheel 90 degrees to the right and hold the steering wheel position.
Does the scan tool indicate that the Torque Sensor Main data parameter changes state wile turning the steering wheel and is less than the specified value?		 17.2 N.m (12.6 lb ft) Go to Diagnostic Aids Go to Step 3 
3 Replace the electric power steering (EPS) assembly. Refer to Steering Column Replacement .
Did you complete the repair?		 - Go to Step 4  -
4
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC.
Does the DTC reset?		 - Go to Step 2  System OK
scientia non olet · About LEMON Manuals