LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1838 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Manifold Absolute Pressure Sensor
    GM897253Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor with port seal into the intake manifold.
  2. Connect the MAP sensor electrical connector. Push in the connector until a click is heard and pull back to confirm a positive engagement.
  3. Install the outlet resonator/duct assembly into position.
  4. Connect the PCV fresh air vent hose assembly.
    5. NOTE: Refer to Fastener Notice .
  5. Tighten the clamp at the throttle body assembly.

    Tighten:  Tighten the clamp to 4 N.m (36 lb in).

  6. Position the outlet resonator/duct assembly up with the support bracket and install the push-pin.
  7. Tighten the clamp at the air cleaner assembly.

    Tighten:  Tighten the clamp to 4 N.m (36 lb in).

  8. Connect the IAT sensor connector.
scientia non olet · About LEMON Manuals