LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1838 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Knock Sensor
    GM895903Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (2.2L (L61) and 3.5L (L66))
  2. Remove the knock sensor harness connector.
  3. Remove the knock sensor connector from the retaining clip by inserting a flat-bladed screwdriver between the connector and clip while sliding the connector upward.
  4. Remove the knock sensor.
scientia non olet · About LEMON Manuals