LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1838 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Coil & Module Assembly
    GM412144Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil housing to the camshaft cover.
    2. NOTE: Refer to Fastener Notice .
  2. Install the ignition coil housing retaining bolts.

    Tighten:  Tighten the retaining bolts to 10 N.m (89 lb in).

  3. Install the ICM. Refer to Ignition Control Module Replacement .
  4. Install the accelerator and cruise control cables bracket.
  5. Install the accelerator and cruise control cables bracket bolts.

    Tighten:  Tighten the retaining bolts to 10 N.m (89 lb in).

  6. Install the accelerator and cruise control cables to the bracket.
scientia non olet · About LEMON Manuals