LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1838 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Vent Solenoid
    GM932641Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP vent solenoid by gently turning the solenoid clockwise until it clicks into position.
  2. Connect the EVAP vent solenoid electrical connector.
    3. Fig 2: View Of Evaporative Emission Vent Solenoid
    GM927741Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the EVAP canister bracket-to-underbody fasteners.

    Tighten:  Tighten the EVAP canister-to-body nuts to 8 N.m (71 lb in).

  4. Lower the vehicle from the hoist.
scientia non olet · About LEMON Manuals