LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1838 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal Position Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Accelerator Pedal Position Assembly
    GM898158Courtesy of GENERAL MOTORS CORP.
  1. Install the upper attachment bolt into the APP assembly.
  2. Install the APP assembly into the vehicle.
    3. NOTE: Refer to Fastener Notice .
  3. Install the attachment bolts into the APP assembly.

    Tighten:  Tighten the accelerator pedal position assembly-to-brake bracket bolt to 25 N.m (18 lb ft).

  4. Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
  5. Install the APP sensor connect CPA.
scientia non olet · About LEMON Manuals