Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The condition for the DTC is no longer present and the DTC is cleared with a scan tool.
The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

DTC B0005

Step	Action	Yes	No
Schematic Reference: CELL LINK Connector End View Reference: CELL LINK
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Park Brake Switch parameter in the brake control module (BCM) data list. Does the scan tool indicate that the Park Brake Switch parameter is OK?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Turn OFF the ignition. Disconnect the park brake switch. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Park Brake Switch parameter. Does the scan tool indicate that the Park Brake Switch parameter is OK?	Go to Step 5	Go to Step 4
4	Test the signal circuit of the park brake switch for a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 7	Go to Step 6
5	Replace the park brake switch. Refer to Park Brake Warning Lamp Switch Replacement . Did you complete the repair?	Go to Step 7	-
6	Replace the BCM. Refer to Control Module References . Did you complete the repair?	Go to Step 7	-
7	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2