LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1836 (Drum Brake System) >> Repair Instructions >> Wheel Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Using J 38400 To Spread The Brake Shoes Apart
    GM142285Courtesy of GENERAL MOTORS CORP.
  1. Use the J 38400  in order to spread the brake shoes apart (1). See Special Tools .
    2. Fig 2: Removing/Installing Wheel Cylinder
    GM142296Courtesy of GENERAL MOTORS CORP.
  2. Install the wheel cylinder.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the wheel cylinder bolts (2).

    Tighten:  Tighten the bolts to 15 N.m (11 lb ft).

  4. Remove the cap from the brake pipe and install the brake pipe to the wheel cylinder.

    Tighten:  Tighten the nut to 19 N.m (14 lb ft).

  5. Install the brake drum. Refer to Brake Drum Replacement .
  6. Bleed the hydraulic brake system at the wheel cylinder. Refer to Hydraulic Brake System Bleeding (Pressure) or Hydraulic Brake System Bleeding (Manual) .
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals