LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1836 (Drum Brake System) >> Repair Instructions >> Drum Brake Hardware Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Brake Shoe Assembly Lubrication Areas
    GM231Courtesy of GENERAL MOTORS CORP.
  1. Apply GM P/N 1052196 (Canadian P/N 5264008) brake lubricant or equivalent to the backing plate in the following areas:
    • The brake shoe contact points on the backing plate
    • The adjuster screw threads and inside diameter of the adjuster socket
    2. Fig 2: View Of Brake Components
    GM695644Courtesy of GENERAL MOTORS CORP.
  2. Install the brake shoe hold-down pins, springs and retainers (4) to the brake shoes.
    3. Fig 3: Identifying Park Brake Adjuster Actuator Components
    GM178990Courtesy of GENERAL MOTORS CORP.
  3. Install the adjuster spring (2) to the brake shoe.
    4. Fig 4: View Of Brake Components
    GM695644Courtesy of GENERAL MOTORS CORP.
  4. Install the adjuster spring hook end to the tab on the adjuster actuator (1).
  5. Install the return spring (7) to the brake shoes.
  6. Adjust the brake shoes. Refer to Drum Brake Adjustment .
  7. Check for proper park brake cable Adjustment. Refer to Park Brake Adjustment .
  8. Install the brake drum. Refer to Brake Drum Replacement .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals