LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1836 (Drum Brake System) >> Repair Instructions >> Drum Brake Backing Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the backing plate.
    2. Fig 1: Identifying Wheel Bearing/Hub
    GM864720Courtesy of GENERAL MOTORS CORP.
  2. Install the wheel bearing/hub assembly. Refer to rear Wheel Bearing and Hub Replacement .
    3. Fig 2: Removing/Installing Wheel Cylinder
    GM926774Courtesy of GENERAL MOTORS CORP.
  3. Install the wheel cylinder. Refer to Wheel Cylinder Replacement .
    4. Fig 3: View Of Rear Park Brake Cable End Fitting
    GM890720Courtesy of GENERAL MOTORS CORP.
  4. Install the park brake cable (1) to the backing plate.
    5. Fig 4: View Of Brake Components
    GM695644Courtesy of GENERAL MOTORS CORP.
  5. Install the park brake cable to the park brake actuator (5).
  6. Install the brake shoes. Refer to Brake Shoe Replacement .
  7. Adjust the brake shoes. Refer to Drum Brake Adjustment .
  8. Adjust the park brake cable. Refer to Park Brake Adjustment .
  9. Install the brake drum. Refer to Brake Drum Replacement .
  10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals