LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1836 (Drum Brake System) >> Repair Instructions >> Brake Drum Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check to ensure that the park brake is fully released.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    4. Fig 1: View Of Brake Drum
    GM890712Courtesy of GENERAL MOTORS CORP.
  4. Remove the brake drum.
  5. If the brake drum is to be reinstalled to the vehicle, use the J 41013  to clean any rust or corrosion from the hub/flange mating surface of the brake drum.

    If necessary, carefully remove any corrosion from the edge of the drum braking surface in order to ease installation.

  6. Use the J 42450-A  to clean the wheel hub flange.
scientia non olet · About LEMON Manuals