LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1834 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Fig 1: View Of Stabilizer Bar Clamp & Bolts
    GM930236Courtesy of GENERAL MOTORS CORP.
  3. Loosen the stabilizer bar clamp bolts.
  4. Fig 2: Stabilizer Link To Stabilizer Bar Nut
    GM1830224Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Hold the ball shaft secure with a TORX® bit, when removing the nut.
  5. Remove the stabilizer link to stabilizer bar nut.
  6. Fig 3: Stabilizer Link To Control Arm Nut
    GM1830228Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When disconnecting the stabilizer link, hold the link with a wrench to prevent turning.
  7. Remove the stabilizer link to control arm nut.
  8. Remove the stabilizer link from the vehicle.