LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1834 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the stabilizer link through the control arm.
    2. Fig 1: Stabilizer Link To Control Arm Nut
    GM1830228Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: When connecting the stabilizer link, hold the link with a wrench to prevent turning.
  2. Install the stabilizer link to control arm nut.

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

    3. Fig 2: Stabilizer Link To Stabilizer Bar Nut
    GM1830224Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Hold the ball shaft secure with a TORX® bit, when installing the nut.
  3. Install the stabilizer link to stabilizer bar nut.

    Tighten:  Tighten the nut to 47 N.m (35 lb ft).

    4. Fig 3: View Of Stabilizer Bar Clamp & Bolts
    GM930236Courtesy of GENERAL MOTORS CORP.
  4. Install the stabilizer bar clamp bolts.

    Tighten:  Tighten the bolts to 70 N.m (52 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals