LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1834 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the insulators the stabilizer bar.
  2. Fig 1: View Of Stabilizer Bar Clamp & Bolts
    GM930236Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the stabilizer bar clamp bolts.

    Tighten:  Tighten the bolts to 70 N.m (52 lb ft).

  4. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .